1010music Blackbox User Manual page 15

Parameter
Launch
Mode
Attack
Decay
Sustain
Release
4/10/19 6:08 PM
Page 14 of 49
Description
This controls how a note trigger
affects the playback of a pad.
The time it takes for the sound to reach its loudest
level
How long it takes for the sound to go from the
initial peak to the sustain level
The volume level that the sound maintains when
you hold a note
The release specifies how long the note will
continue to play and fade out when the note is
released. In Gate mode, the release begins when
the touch ends, the gate signal goes low, or the
MIDI note off event occurs. In Toggle mode, the
release begins when the toggle off occurs. In
Trigger mode with sample pads the release
begins when reaching the Loop End point in loop
mode, or the Start + Len point when not looping.
In Trigger mode for Clips and Slicers, the
release has no effect.
BLACKBOX USER MANUAL v 0.9.8
Range of Values
Trigger: Activate the Pad by touching the pad or
through MIDI note on. Blackbox will start playback
of the WAV file and play through to the end.
Gate: Begin the WAV file playback in the same
manner as Trigger mode. But in Gate mode,
playback will stop when you release the touch or
the MIDI note is released.
Toggle: Begin the WAV file playback in the same
manner as Trigger mode. When another trigger
event happens, the playback will stop.
0.0 to 100.0% The attack
percentage is a logarithmic
scale between 0 and 9 seconds.
0.0 to 100.0% The decay
percentage is a logarithmic
scale between 0 and 38
seconds.
0.0 to 100.0%
0 to 100% The release
percentage is a logarithmic
scale between 0 and 38
seconds.
Copyright 1010music LLC 2019
Mod
Target?
No
No
No
No
No