Set Up A Sample Pad - 1010music Blackbox User Manual

Set up a Sample Pad

Use a sample pad when you only want to play or loop through a WAV file with no slicing and no synchronization within the
playback. This Pad Mode supports reverse playback, along with forward and bidirectional looping. For example, you might
use Sample Mode with a melodic sample. You can also use the Start and Len parameters to play a portion of the WAV file.
Sample Mode Parameters
Follow the steps in the previous section to create a sample pad. An example of a good WAV file to use for a sample pad is
\drums\Kick 1.wav. Press the INFO button to cycle through the Pad Parameters screens and the Waveform screen. Use
the control knob closest to the parameter name to change the value of a parameter. The table below describes the
parameters available that are specific to a sample pad.
Parameter Description
Loop Mode Controls whether the WAV file plays in a loop,
and the direction of the loop.
When looping is enabled, if you have the
Launch Mode set to Trigger, looping will
happen for the duration of the Release phase
of the note.
If you have the Launch Mode set to Gate,
looping plays through the gate pulse and the
release time.
If you have the Launch Mode set to Toggle,
looping starts to play when the initial pulse is
received and continues until the terminating
toggle pulse is received.
If Loop Mode is Bidirect, and Rev is ON, play
back will start from the end of the sample,
and then loop as described, but starting with
the Loop End to Loop Start pass.
Rev When Reverse is ON, the WAV file will play in
reverse.
Start Point where playback will begin when playing
forward or ends when playing in reverse.
Expressed in samples.
4/10/19 6:08 PM
Page 16 of 49
BLACKBOX USER MANUAL v 0.9.8
More Sample Mode Parameters
Range of Values
None: Plays once from the value assigned to
the Start parameter through the value assigned
to the Length parameter.
Forward: Plays from the value assigned to
the Start parameter through the value assigned
to the Loop End Parameter, then jumps back to
the value of the Loop Start parameter. Play
continues to loop between Loop Start and
Loop End for the duration of the note.
Bidirect: Works similarly to forward, but loop
playback proceeds from Loop Start to Loop
End then backwards to Loop Start. It then
repeats the looping back and forth.
ON, OFF
0 to number of samples in the file
Copyright 1010music LLC 2019
Mod
Target?
No
No
Yes