Table of Contents
Advertisement
Managing the Hub
Console Command Reference
Status
Information
Port
Port Status
Link Beat
MAC address
INTRUDER
ADDRESS
3-20
Redundant Power Supply status:
•
NOT CONNECTED means the RPS is not attached to the device.
•
CONNECTED/FAULT means the RPS is attached but is reporting an
error.
•
CONNECTED/GOOD means the RPS is attached with no errors, but
has not been enabled.
•
CONNECTED/GOOD/ACTIVE means the RPS is attached with no
errors, and is active (the primary power supply is not operating and
the RPS has been initiated as a backup system).
a table with the port information described as follows:
What It Means
The port ID. (Additionally, bkup indicates that the port is configured as the
backup link, pri indicates that the port is the primary link—see the Backup
command).
The status of each port:
ON means the port is enabled and is not auto-segmented.
OFF means that the port has been disabled by the Port command or
because of a security violation.
PARTITIONED means the port has been auto-partitioned.
(See "Auto-Partitioning" in the chapter that provides information on the
Product Description. )
ON/REVERSED means that reversed wiring polarity on the receive pair has
been detected on a twisted-pair cable and the hub has compensated.
Informs the hub of the presence of a device connected to it over twisted-
pair cable.
The unique 12-digit link-layer address for the hub. (Also called Ethernet
address or physical address.)
The address of a device not authorized to access the hub.
Advertisement
Table of Contents
