Table of Contents
Advertisement
Managing the Hub
Console Command Reference
network management— also called SNMP event alarms). The start of the table
is shown below. Up to ten network management stations can be entered into
the table. Entry 0 (zero) is used for the "all managers allowed" entry.
ID
0
1
2
The hub is initially shipped with all network management stations allowed to
manage the hub, but the "all managers" entry does not identify where alarms
are to be sent. Specific addresses must be entered into the table to identify
where the alarms should be sent.
N o t e
If you want to restrict which management stations are allowed to manage the
hub, delete entry 0. Then add the allowed management stations with the A
command.
At the interface prompt, enter MA; the current authorized managers list is
displayed and you are prompted to add or delete an entry in the list, or to enter
E to end your editing.
To add an entry, enter A at the prompt. Enter the IP or IPX address of the
network management station, or enter A to allow all managers to manage the
hub, then indicate at the next prompt whether this management station should
receive alarms generated by the hub. A new entry is added to the list.
3-10
Manager Address (IP or IPX)
All managers allowed
Receive Alarms?
NA
Advertisement
Table of Contents
