HP J3188A Installation And Reference Manual page 48

Managing the Hub
Console Command Reference
Showing the Security Configuration
Enter the command SE SH to display the security configuration for all of the
hubs ports. A table like the following is presented:
Port
1
2
3
The vertical bar between Send Alarm and Disable Port indicates that the value
for the Disable Port parameter is not directly configurable. This parameter is
automatically set by the Address Selection Method. If the method is either
First Heard or Assigned, and if at least one of the other security parameters
is set to YES, the Disable Port parameter will be YES. If the method is
Continuous, the Disable Port parameter is always automatically set to NO.
Clearing Security Violation Indicators
Enter the command SE CL to clear any security violation indicators and to
"rearm" the indicators to be ready for the next intrusion. The indications are
slightly different between port security violations and network management
security violations, as described next.
For Port Security. The security violations are indicated by the Security
LED and the LED for the affected port blinking simultaneously, and the
intruder's MAC address being added to the Status command screen for the
affected port. Security violations occur when a non-authorized address is
detected on a port and at least one of the intruder prevention parameters (Send
Alarm or Disable Port) is set to YES.
3-18
Send Alarm when intruder detected? and Eavesdrop prevention?:
These parameters are defined earlier in the chapter under "Security
Configuration Parameter Definitions".
The values you select for these parameters will be applied to all the
twisted-pair ports for which you have selected (or retained) the address
selection method.
ADDRESS
SELECTION AUTHORIZED
METHOD ADDRESS
CONTINUOUS 123456-890123
CONTINUOUS NONE
FIRST HEARD 123456-789012
EAVESDROP SEND
PREVENTION ALARM
YES NO
NO NO
YES YES
DISABLE
PORT *
NO
NO
YES