Page 1
Please make sure the package contains the following items: M4x20 screw x 2 Screw fixing seat x 4 ST4x20 screw x 4 M3x10 screw x 1 M3x5 screw x 4 Cable buckle x 1 Wall bracket x 1 Back cover x 1 R26X x 1...
R26X Installation Wall Bracket Installation With 86 embedded box in the wall : Take down the Use the pen to mark Use 2 M4X20 screws to M4x20 screws and the hole location on fix the wall bracket and remove the wall the wall bracket embedded box.
Page 6
R26X Without 86 embedded box in the wall : Use 6mm Drill to drill the red hole you marked Use the pen to mark the before ,and dig a 5cm hole location on the wall depth square hole bracket Use 4 St4X20 screws to fix...
R26X Back cover Installation Make cables go through all the Use 4 M3x5 screws to fix components of the bottom hole , Take down the back the back cover connect with the contacts in the main cover ,cable buckle. board. Then put the cable buckle and...
R26X Device Mounting 2. Push down to fix the device securely. 1. Insert the screws of R26X into the holes on the wall bracket 3. Lock the M3X10 screw at the bottom of device.
Page 9
R26X Interface Description On PCB Board:...
Intercom -> Relay&Input -> Relay ID/DTMF and choose the DTMF code number in corresponding area. IP Announcement 1. While R26X is startup normally, hold the call button for several seconds after the LED light turns blue, voice system will enter IP announcement mode.
Page 12
Notice Information Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without notice, any update to this document can be viewed on Akuvox’ s website: http://www.akuvox.com...
Need help?
Do you have a question about the R26X and is the answer not in the manual?
Questions and answers