Sony POWER HD FX PDW-700 Operation Manual page 219

AUTO The unit is operating in Auto
INTERVAL Interval Rec mode (**M**S:
**M**S Indicates the shooting interval in
minutes and seconds).
MANU The unit is operating in the single-
INTERVAL shot mode of Manual Interval Rec
*FRAME mode (*FRAME: Indicates the
number of frames recorded in one
shot).
INTERVAL The unit is operating in the
**S (M/H) consecutive mode of Manual
*FRAME Interval Rec mode (**S (M/H):
Indicates the trigger interval, in
seconds (minutes or hours),
*FRAME: Indicates the number
of frames recorded in one shot).
LOW LIGHT Depending on the setting, the
subject illumination is inadequate.
ON-BOARD The backup battery of the internal
BATTERY
clock is empty.
EMPTY
DCP If this message continues to
EEPROM appear even after the unit is
DATA NG! powered off and on again several
DR EEPROM times, then the factory adjustment
DATA NG! data is invalid. Contact a Sony
DCP/DR service representative.
EEPROM
DATA NG!
a) Contact a Sony service representative to replace the
battery.
VDR operation messages are displayed in the
setting change and adjustment progress message
display area of the viewfinder screen (see
page 34). Take the actions listed in the following
table.
ILL. Disc! A disc that cannot be used by this
unit was inserted. Insert another
Professional Disc.
ILL. Index! Index file or file system error.
No FS! Exchange or format the disc.
Unknown FS!
No Support! A recorded clip cannot be handled
by this unit. Exchange or format
the disc.
FORMAT The disc could not be formatted
NG! automatically. Exchange the disc.
a)
Disc Damage A disc that cannot be recorded was
inserted. To record, exchange the
disc.
Non AV Full The disc is full. Exchange or
MAX # Files format the disc.
Over DUR!
DI read err The disc was not recognized. Try
Read err ejecting the disc and inserting it
DRV ADJ err again. Or exchange the disc.
Run Salvage A disc that requires salvage was
inserted. To record on the disc,
eject the disc, insert it again, and
execute salvage processing.
Salvage NG! Salvage processing failed.
For details, see "Handling of discs
when recording does not end
normally (salvage function)" on
page 74.
Salvage The loaded disc cannot be
XXXX salvaged by this unit. The
"XXXX" in the message is a code
for XDCAM devices that can
salvage the disc. Refer to the list
of device codes (see page 75) and
salvage the disc using one of the
indicated devices.
REC INHI.! The Write Inhibit tab of the disc is
in the recording disabled position,
or salvage processing needs to be
done on the loaded disc. Set the
tab to the recording enabled
position. Or eject the disc, insert it
again, and perform salvage
processing.
1080/50i The loaded disc has a different
1080/25P resolution or a different system
1080/59.94i frequency. To carry out recording
1080/29.97P operations, exchange the disc, or
720/50P change the resolution or system
720/59.94P frequency.
625/50i
525/59.94i
Operation Warnings 219