Sony POWER HD FX PDW-700 Operation Manual page 155

No. Page Item
16 DCC ADJUST DCC FUNCTION
SEL
DCC D RANGE
DCC POINT
DCC GAIN
DCC DELAY
TIME
DCC PEAK
FILTER
17 AUTO IRIS 2 IRIS WINDOW
IRIS WINDOW
IND
IRIS LEVEL
IRIS APL RATIO (–99 to 99)
IRIS VAR WIDTH 20 to 240 to 479 Adjusts the width of detection frame when the auto
IRIS VAR
HEIGHT
IRIS VAR H POS –460 to 0 to 459 Adjusts the horizontal position of detection frame
IRIS VAR V POS –250 to 0 to 249 Adjusts the vertical position of detection frame
IRIS SPEED
CLIP HIGH
LIGHT
18 GENLOCK GENLOCK
GL HD H PHASE (–99 to 99)
GL SD H PHASE (–99 to 99)
REFERENCE
19 ND COMP ND OFFSET
ADJUST
CLEAR ND
OFFSET
Settings Description
DCC/FIX Enables or disables automatic knee point
adjustment when the OUTPUT/DCC switch is set
to CAM, DCC: ON.
DCC: Automatically adjust the knee point
according to the luminance of the subject.
FIX: Set the knee point to a fixed value.
400%/450%/ Sets the dynamic range when the OUTPUT/DCC
500%/550%/ switch is set to CAM, DCC: ON.
600%
(–99 to 99) Adjusts the DCC minimum knee point.
(–99 to 99) Adjusts the gain to DCC detected value.
(–99 to 99) Adjusts the DCC reaction speed.
(–99 to 99) Adjusts the response sensitivity to the peak of the
DCC detected value.
1/2/3/4/5/6/VAR Selects the auto iris detection window.
VAR: variable
OFF/ON Turns on and off the function which displays a
frame marker for the auto iris detection window.
(–99 to 99) Adjusts the level of the auto iris target value.
Adjusts the mix ratio of auto iris detection peak
value and average value.
iris detection window is set to VAR.
20 to 135 to 269 Adjusts the height of detection frame when the
auto iris detection window is set to VAR.
when the auto iris detection window is set to VAR.
when the auto iris detection window is set to VAR.
(–99 to 99) Adjusts the auto iris speed.
OFF/ON Turns on and off the function which, during auto
iris adjustment, ignores very bright areas by dulling
the reaction to high luminescence.
OFF/ON Turns genlock on and off.
Sets the HD output H phase for genlock operation.
Sets the SD output H phase for genlock operation.
INTERNAL/ Displays the type of reference signal used by this
GENLOCK/ unit.
SDI IN
OFF/ON Turns on and off the mode which sets ND (neutral
density) filter color compensation values.
EXEC Clear ND filter color compensation values.
Menu List 155