File Menu - Sony POWER HD FX PDW-700 Operation Manual

No. Page Item
23 UP UP CON
CONVERTER PROCESS
UC DETAIL
LEVEL
UC CRISPENING (–8 to 7)
UC DETAIL
LIMIT
UC LV DEPEND
LVL
UC DTL
FREQUENCY
UC DTL H/V
RATIO
a) The setting of this item is overridden by the setting of
Other BEFORE END when TYPE DETECTION in
the BATTERY 2 page is set to "OTHER".
b) The setting of this item is overridden by the setting of
Other END when TYPE DETECTION in the
BATTERY 2 page is set to "OTHER".
c) When TYPE DETECTION in the BATTERY 2 page
is set to "AUTO", any batteries other than Sony BP-
series batteries and Anton Bauer intelligent battery
systems are classified as "Others".

FILE menu

No. Page Item
01 USER FILE USER FILE LOAD
USER FILE SAVE
F.ID
USER PRESET
Settings Description
FIELD/ADPT Selects the conversion source picture when SD is
upconverted to HD.
FIELD: Use the field picture.
ADPT: Optimize the ratio of conversion from the
frame or field picture.
(–99 to 99) Adjusts the sharpness of edge enhancement by the
upconverter.
Sets the amplitude width at which the upconverter
does not emphasize low-amplitude signals.
(–99 to 99) Sets the maximum level of edge enhancement by
the upconverter.
(–8 to 7) Sets the luminance of edge enhancement by the
upconverter.
3.2M/4.5M/ Sets the center frequency and frequency properties
5.0M/4.0M of edge enhancement by the upconverter.
3.2M: 3.2 ± 1.1 MHz
4.5M: 4.5 ± 1.4 MHz
5.0M: 5.0 ± 0.7 MHz
4.0M: 4.0 ± 2.0 MHz
(–3 to 4) Sets the horizontal/vertical ratio of edge
enhancement by the upconverter.
d) Flashes once per second when the battery status is
"BEFORE END", and flashes 4 times per second
when the battery status is "END".
e) A setting for this item is required when AU CH34
AGC MODE in the AUDIO-2 page is set to OFF.
f) A setting for this item is required when the DWR-
S01D Digital Wireless Receiver is installed.
g) SDI OUT 1 SELECT or SDI OUT 2 SELECT in the
OUTPUT 1 page of the OPERATION menu must be
set to HDSDI.
Settings
EXEC
EXEC
Blank/up to 16
characters
EXEC
Description
For details, see "Saving and
Recalling User Files" on page
186.
For details, see "Resetting USER
menu settings to the standard
settings" on page 170.
Menu List 157