Toshiba TOSVERT VF-FS1 Instruction Manual page 16

■ Block Write 1, 2
Select data, which is desired to be written in block communications, in Block Communication Write
Data 1 and 2 Parameters (
is reset, such as when power is turned off. When the setting is completed, turn off and then on the
power.
No. Block Write Data
0 No selection
1 Command 1 (FA00)
2 Command 2 (FA20)
3 Frequency Command Value (FA01)
4 Terminal Board Output Data (FA50)
5 Communication Analog Output (FA51)
6 Motor speed command (FA13)
* When "No selection" is specified in the parameters, no data will be written even though write data
is specified.
■ Block Read 1 to 5
Select read data, which is desired to be read in block communications, in Block Communication
Read Data 1 and 5 Parameters (
the system is reset, such as when power is turned off. When the setting is completed, turn off and
then on the power.
No. Block Read Data
0 No selection
1 Status 1 (FD01)
2 Output Frequency (FD00)
3 Output Current (FE03)
4 Output Voltage (FE05)
5 Alarm Information (FC91)
6 PID Feedback Value (FE22)
Input Terminal
7
(FD06)
Output Terminal Board Monitoring
8
(FD07)
9 Analog Monitoring VIA (FE35)
10 Analog Monitoring VIB (FE36)
11 Output motor speed monitor (FE90)
* Output current (FE03), output voltage (FE05) and PID feedback value (FE22) and Output motor
speed monitor (FE90) will become hold data during a trip. Otherwise, real-time data appears.
* "0000" will be returned as dummy data, if "0 (No selection)" is selected for the parameter and
"read" is specified.
, ). This parameter becomes effective when the system
For data details, see:
－
"8.1 Command by communication"
"8.1 Command by communication"
"8.1 Command by communication"
"8.3 Control of input/put signals from com-
munication"
"8.3 Control of input/put signals from com-
munication"
"8.1 Command by communication"
to
For data details, see:
－
"8.2 Monitoring from communication"
"8.2 Monitoring from communication"
"9. Parameter data"
"9. Parameter data"
"8.2 Monitoring from communication"
"9. Parameter data"
Board Monitoring "8.3 Control of input/put signals from com-
munication"
"8.3 Control of input/put signals from com-
munication"
"8.3 Control of input/put signals from com-
munication"
"8.3 Control of input/put signals from com-
munication"
"8.2 Monitoring from communication"
15
). This parameter becomes effective when
E6581393