Table of Contents
Advertisement
respective association group will receive a common wireless command.
Association Groups:
1
Nodes controlled by Thermostat Node Set command (max. nodes in group: 4)
2
Nodes controlled by Binary Switch SET command (max. nodes in group: 1)
3
Nodes to receive unsolicited Battery Level Reports (max. nodes in group: 1)
4
Nodes to receive Thermostat Set Point Reports (max. nodes in group: 1)
5
Nodes to receive unsolicited Sensor Multilevel Reports (max. nodes in group: 1)
Set and unset associations to actuators
Associations can be assigned and remove either via Z-Wave commands or using the device itself.
SA
To assign associations with devices you wish to control with the thermostat do the following steps: Set DIL switch 1
on the back of the unit to 'ON' position, scroll through the function menu by rotating the dial, select "A". Press the
dedicated button on the target device you wish to control.
To disassociate an association do the following steps: Set DIL switch 1 on the back of the unit to 'ON' position, scroll
through the function menu by rotating the dial, select "D". Press the dedicated button on the target device you wish
to disassociate.
Special Functions as Z-Wave Controller
As long as this device is not included into a Z-Wave network of a different controller it is able to manage its own Z-
Wave network as primary controller. As a primary controller the device can include and exclude other devices in its
own network, manage associations, and reorganize the network in case of problems. The following controller
functions are supported:
Include other device in own network
CI
Communication between two Z-Wave devices only works if both belong to the same wireless network.
Joining a network is called inclusion and is initiated by a controller. The controller needs to be turned into the
inclusion mode. Once in this inclusion mode the other device needs to confirm the inclusion - typically by pressing a
button.
For Inclusion of Z-Wave devices into the thermostats network do the following steps: Set DIL switch 1 on the back of
the unit to 'ON' position, scroll through the function menu by rotating the dial, select "I". Press the dedicated button
on the target device to include it. Once the character starts flashing the installer has 60 sec to activate the 3rd party
unit, once the 3rd party unit has been activated the process must be completed within 240 sec or the thermostat will
timeout.
If current primary controller in your network is in special SIS mode this and any other secondary controller can also include and
exclude devices.
To become primary a contoller have to be resetted and then include a device.
Exclude device from network
Advertisement
Table of Contents
