Danfoss MCX-RTU User Manual page 18

User Guide | MCX-RTU Rooftop
© Danfoss | ADAP-KOOL® | 2018.11
GEN Parameters > Function
General
y21 Avg RH1 Select RH1 sensor for Average(None/Local/
Glbl1-5)
y22 Avg RH2 Select RH2 sensor for Average(None/Local/
Glbl1-5)
y23 Avg RH3 Select RH3 sensor for Average(None/Local/
Glbl1-5)
y24 Not Used Not Used
y25 Not Used Not Used
y30 SelectExhaustFan Select Exhaust Fan Schedule(0-16)
y31 Aux RO 1 Schedule Select Aux RO 1 Schedule(0-16)
y32 Aux RO 2 Schedule Select Aux RO 2 Schedule(0-16)
y33 Aux RO 3 Schedule Select Aux RO3 Schedule(0-16)
y34 Aux RO 4 Sche- Select Aux RO4 Schedule(0-16)
dule
y35 Enable Broadcast Enable Broadcast feature(No/Yes)
y36 Night Shutdown Night Shutdown(No/Yes)
y37 Enable Logging Enable Logging(No/Yes)
y38 Logging Interval Set Logging Interval
FAN Parameters > Function
Fan
FN1 Fan Off Delay Fan Off Delay (0-30)
FN2 Fan Proof Value Fan Proof Value (0.0-100.0)
Used with the Fan CT AI . If AI is above this
value the is ON
FN3 Min Fan Speed Min Fan Speed when in Fan Only Mode
(0.0-100.0)
FN4 Fan PI Gain Fan PI Gain Value (0.0-100.0)
FN5 FanPIIntegrati- Fan PI Integration Time (6-1000)
onTime
FN6 Building Press Building Pressure Target(-1.00-1.00)
Target
FN7 OvrdFanSpeed Stage One Fan Speed if exhaust fan one
enabled
FN8 OvrdFanHigh Stage Two Fan Speed if exhaust fan two
enabled
FN9 Cond Target 1 Condenser Target
FNA Cond Target 2 Condenser Target if Reheat enabled
Default Units
None
None
None
0
0
0
0
0
Yes
No
No
1 m
Default Units
2 m
2.0 a
30.0 %
5.0
60
0.00
350 PSI bar/psi
400 PSI bar/psi
RS8KE102 | 18