Miele KFN 37692 iDE Operating And Installation Instructions page 72

Problem solving guide
Message
The ice maker 
and alarm  symbols
are flashing in the
display. The indicator
light on the ice cube
maker is also flashing.
 lights up in the
display.
The power failure
symbol , appears in
the display and the
alarm tone sounds.
The temperature display
will show the warmest
temperature recorded in
the freezer during a
power failure or an
interruption to the
power supply.
"F0 to F9" appears in
the display.
"FE*" appears in the
display.
72
Cause and remedy
The is a fault with the ice cube maker.
 Call the Miele Service Department.
The Replace filter reminder setting has been
activated. This is the reminder to change the filter
(Active AirClean).
 Replace the filter in the holder (see "Cleaning and
care - Replacing the filter").
 Reset the counter (see "Selecting further settings -
Filter replacement indictor ").
Indication of an power failure: the temperature in the
appliance over the last few days or hours has risen
too high because of a power failure or interruption to
the power supply.
The appliance will go back to the last temperature
setting when the power is back on.
 Press the Alarm off button.
The warmest temperature displayed will disappear.
The display will then revert to showing the current
temperature in the freezer section.
 Depending on the temperature displayed, you
should check whether food in the freezer has
started to thaw or has defrosted. If it has, it should
be used as soon as possible. Defrosted food may
only be re-frozen after it has been cooked.
There is a fault.
 Call the Miele Service Department.
There is a fault.
 Call the Miele Service Department.