Miele KFN 37692 iDE Operating And Installation Instructions page 102

Installing the appliance
 Push the appliance into the niche
until all fixing brackets at the top and
bottom are in line with the front edge
of the housing unit side wall.
This will create a gap all round of 42
mm to the front edges of the housing
unit side walls.
–  With 16 mm thick walls:
The spacers should touch the front
edge of the housing unit side walls at
the top and bottom.
–  With 19 mm thick walls:
The front edges of the top and
bottom hinges should be flush with
the front edge of the housing side
wall.
102
On furniture with door fittings (e.g.
stubs, seals etc.):
the dimension of these must be taken
into account when making sure there
is a gap all round of 42 mm.
 Pull the appliance forwards by the
appropriate dimension.
 Check again, to make sure there is a
gap of 42 mm to the front edges of
the door fittings.
Tip: If possible, remove door fittings
and push the appliance into the niche
until all fixing brackets at the top and
bottom are in line with the front edge of
the housing unit side wall.
 Align the appliance on both sides by
altering the adjustable feet using the
spanner supplied.