Fitting The Furniture Doors - Miele KFN 37692 iDE Operating And Installation Instructions

Fitting the furniture doors

The upper edge of the appliance
furniture doors should be aligned with
the height of the furniture doors of the
adjacent kitchen units.
The furniture doors must be mounted
free of tension.
The following chapter describes the
installation of furniture doors with a
furniture front of at least 16-19 mm
thickness.
Carry out the following steps on both
doors.
 A gap of 8 mm is set ex-works
between the appliance door and the
fixing bracket. Double check this gap
and reset it if necessary.
 Push fitting aids  up to the height of
the furniture door: the lower edge X
of the fitting aids must be at the same
height as the upper edge of the
furniture door being fitted (see  on
the diagram).
Installing the appliance
Tip: Push fitting aids  together with
the furniture front up to the height of the
adjoining unit furniture doors.
 Undo nuts  and take fixing
bracket  off together with fitting
aids .
105