Canon imageRUNNER ADVANCE 8205 Service Manual page 82

Item
Area Below the
Developing
Assembly
Developing Roller
Developing Sleeve
Holder
Lower Side of
Cylinder
Toner Receptacle
Tray
Waste Toner
Container
ETB Driver Roller
ETB Idler Roller
Fixing Cleaning
Web Guide
Fixing Inlet Guide
Fixing Oil Receiver
Fixing Right Stay
Dowel
Dowel Holder
Fixing Inlet Sensor
Flag
Fixing Roller Static
Eliminator
Inner Delivery
Roller
Upper Separation
Claw
Feed Guide
Rollers/Wheels
Separation Static
Eliminator
Duplex Unit
Cleaning Brush
Registration Unit
Magnet
imageRUNNER ADVANCE 8200 Series Service Guide
imageRUNNER ADVANCE 8200 Series Service Guide
Maintenance Interval (Sheets)
250,000 300,000 500,000
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
As
1,000,000
Needed
Remove any toner that has
Clean scattered after removing the
Developing Assembly.
Clean with a lint-free cloth
moistened with alcohol.
Remove the toner on the
Clean
tray.
Clean when the Waste
Toner Container Is Full
message is displayed.
Clean with a lint-free cloth
moistened with alcohol.
Clean with solvent and a
lint-free cloth. Remove any
lint that covers the Inlet
Sensor Flag.
Wipe with a dry, lint-free
cloth.
Clean with solvent and a
lint-free cloth.
Wipe with a dry, lint-free
cloth.
Clean with solvent and a
lint-free cloth.
Only clean if this part is not
replaced. Clean with solvent
and a lint-free cloth.
Remove paper lint with a
lint-free cloth and cleaning
tool.
Clean with a lint-free cloth
moistened with alcohol.
Remove toner and paper
lint with a blower.
Remove paper lint that was
collected by the cleaning
brush with a blower.
Clean with a lint-free cloth
moistened with alcohol.
Remarks
November 2012
Page 75