Set Up - Invacare Perfecto2 Series User Manual

Usage in environments other than those described may result in
the need for increased equipment maintenance. The air intake of
the unit should be located in a well ventilated area to avoid
airborne pollutants and/or fumes. DO NOT use in a closet.

Set Up

1. Plug in power cord to an electrical outlet.
2. Connect Humidifier (If So Prescribed)
DO NOT fill humidifier bottle with hot water. Allow boiled
water to cool to room temperature before filling.
DO NOT overfill humidifier.
DO NOT reverse the oxygen input and output connections.
Water from the humidifier bottle will travel through the cannula
back to the patient.
When using tubing connections longer than 2.1 m (7 feet) in
length, position the humidifier as close to the patient as possible
to allow for maximum humidification output.
NOTE: For this procedure, refer to FIGURE 6.1, FIGURE 6.2 on
page 18, FIGURE 6.3 on page 20.
1. Remove cap from bottle.
2. Fill humidifier with boiled tap water or bottled water to the
level indicated by the manufacturer. Boil tap water for
approximately 10 minutes and cool to room temperature
prior to use.
Part No 1163147
SECTION 6—OPERATING INSTRUCTIONS
WARNING
17 Perfecto ™Series
2