Port Configurations (Factory Set-Up); Port Configurations For Systems With Dlx-Rem2Xx (Eu-Version With Modulite Seat) - Invacare LiNX Service Manual

Invacare® LiNX
DLX-PM75AL, DLX-PM120AL
A LiNX communication bus
B Motor / park brake port M1
C Battery port
D Motor / park brake port M2
E Actuator ports
F Lighting port
G Utility port

3.7.1 Port configurations for systems with DLX-REM2xx (EU-Version with Modulite seat)

Channel Seating motion (Icon)
Tilt
A
B Recline
Right leg
C
Left leg/
D
Center-mounted
legrest
Lifter
E
12

3.7 Port configurations (Factory set-up)

Actuator ports, properties and behavior per actuator are
defined by Invacare. You can change speed, direction and
operation mode. This is done in different menus, refer to
7.5 Modifying seating parameters, page 62.
Seating motion
The seating movement is called seating motion. The seating
motion defines the icon displayed on the user interface,
overall speed, the individual actuators and their speeds. A
seating motion can control one or more actuators. There are
six seating motions defined in the factory set-up.
Seating function
The seating function is the user input and defines how the
motion is operated.
The "AL" power modules that feature actuators and
lights, have two actuator ports. If required, the system is
completed with the DLX-ACT200 or DLX-ACT400, based on
the configuration. The following chapters detail the port
set-up per module/configuration.
Both legs
Seating function (Operation)
Proportional FWD/REV
Proportional FWD/REV
Proportional FWD/REV
Proportional FWD/REV
Proportional FWD/REV
1605129-C