Load Cell Wiring - Rice Lake IQ plus 310A XPCD Technical And Service Manual

2.6

Load Cell Wiring

The load cell wiring from the IQ plus 310A has been connected to the intrinsic safety barriers at the factory, (see
Figure 2-4). The barriers are located in the bottom of the enclosure.
Wire the load cell cable from the load cell or junction to terminal block TB4 (shown below). If using six-wire
load cell cable (with sense wires), remove jumpers JP1 and JP2. For four-wire installation, leave jumpers JP1 and
JP2 on.
12 IQ 310A XCPD Technical/Service Manual
TB1
TB3
TB2 TB4
Figure 2-5. Load Cell Wiring
JP1
+SENSE
TB5
TB7
JUMPER
JP2
-SENSE
TB8
TB6
JUMPER
JP1
TB3
JP2
TB4
+SENSE
JUMPER
-SENSE
JUMPER