ASSEMBLY
Throttle Linkage and
Ignition Leads
1.
Close choke and remove air
filter cover.
2.
Place throttle wire assembly (A)
into adjustment fixture (B) and
install wire end into large
carburetor throttle swivel hole
(C).
3.
Turn throttle wire retaining clip
(X) clockwise to lock into place.
4.
Check throttle for freedom of movement and that wide open throttle /
low idle extremes are adjusted properly.
Note: The throttle linkage must be adjusted by moving the
adjustment nut (D). Consult with your dealer for correct
adjustment procedure.
5.
Tighten nut (E).
6.
Connect 2 ignition stop leads (F, G)
from throttle cable assembly to 2
ignition leads (F, G) on engine.
7.
Install air filter and cover.
Blade Installation
You must install the U-Handle and all Blade Conversion parts
shown in the following instructions before operating this unit
with a metal blade, otherwise serious injury may result.
Shield with cutoff knife is for use with the Nylon Line Head only.
Install shield without cutoff knife when using plastic or metal
blades, or serious injury may result.
18
A
B
D
E
C
F, G
C302
X
F, G
X7502350400
© 5/2018 ECHO Inc.