Nylon Line Head Disassembly Instructions; Nylon Line Replacement - Shindaiwa C302 Operator's Manual

C302
2. Remove plug (A) and check
level of grease.
3. Add grease if necessary. DO
NOT over-fill.
Drive Shaft
1. Loosen screw (B) and remove
locating screw (C). Pull gear
case and shield from drive shaft
housing.
2. Pull flexible cable from the drive
shaft housing, wipe clean and
re-coat with 15 ml (0.5 oz.) of
grease.
3. Slide the flexible cable back in the drive housing. DO NOT get dirt on
the flex cable.
4. Install the gear housing and shield assembly.

Nylon Line Head Disassembly Instructions

Note: For normal use, Speed Feed
necessary. However, if circumstances require disassembly,
follow these instructions.
1. Press top of locking tabs (A) on
both sides of Speed Feed
head to release cover (B) from
eyelet carrier (C).
2. Remove cover from eyelet
carrier.

Nylon Line Replacement

Wear gloves or personal injury may result:
Cutoff knife is sharp.
◆
X7502350400
© 5/2018 ECHO Inc.
B
®
head disassembly is not
®
C
MAINTENANCE
C
A
A
B
43