Throttle Linkage And Ignition Leads - Shindaiwa BCK-10A Instructions Manual

Install Harness Hanger
1. Slide harness hanger (A) on to outer drive shaft tube (B) and loosely
attach with 5 mm x 12 mm screw (C) and nut (D). Do not tighten screw
securely until final adjustments are completed.
Install Power Head
1. Slide outer drive shaft assembly into power head clamp, and align
power head with gear case.
2. Secure drive shaft assembly with clamping bolt.
Install Handlebar Bracket and Handlebar
1. Install lower handlebar cap (A) and handle bar mounting bracket (B) on
outer drive shaft tube (C) using (2) 5 mm x 25 mm socket head cap screws
(D). Do not tighten screws securely until final adjustments are completed.
2. Place handle bar (E) in mounting bracket, and secure with upper handlebar
cap (F) and (4) 5 mm x 25 mm socket head cap screws (D). Do not tighten
screws securely until final adjustments are completed.

Throttle Linkage and Ignition Leads

1. Thread throttle cable adjuster (A) into throttle cable bracket (B), and install
wire end into large carburetor swivel hole (C). Check throttle for freedom
of movement and that wide open throttle/low idle extremes are adjusted
properly. Turn the cable adjuster in or out to make adjustments. After
adjusting, hold the cable adjuster (A), and tighten the cable adjuster nut (D)
against the cable bracket (B) to lock the setting.
2. Connect 2 ignition stop leads from throttle cable tubing to ignition leads on
engine (E) and grounding screw (F).
3. Reinstall the air cleaner cover.
B
C
B
A
D
E
B
A
C
D
F
A
D
C
D
F
E
7