Assembly Of The Handle; Throttle Cable Adjustment - Shindaiwa T300 Owner's/Operator's Manual

Assembly of the Handle

T300
WARNING!
NEVER operate this machine
without the front handle.
Operating without the front handle may
result in serious injury.
NOTE:
Tighten four bolts diagonally to properly
secure the handle.
NOTE:
Adjust the handle at the best position for
operator comfort.
1. Put four square nuts in the recesses
on the underside of the barrier.
2. Fit the handle and barrier over the
outer pipe and tighten four bolts.
HANDLE
OUTER PIPE
BARRIER
BOLT
NUT
8
C300
1. Loosen the two bolts of the lower cap
and remove the lower cap.
2. Position the handle bracket against the
handle label located on the outer tube.
3. Attach the lower cap with the two bolts
and tighten the bolts. Make sure the
front handle is in position per the
illustration.
4. Secure the cable to the outer pipe with
the two bands as the illustration shows.
The two bands are in the tool bag.
HANDLEBAR
HANDLE BRACKET
HANDLE LABEL
BARRIER
BAND
THROTTLE GRIP
BOLT
LOWER CAP
Throttle Cable
Adjustment
1. Pull the throttle trigger gently,
and check for free-play of
approximately 5mm.
2. If free-play is out of specifications:
(a) Slide the cable cap toward th
muffler side until the adjusting
nut and the lock nut appear.
(b) Loosen the lock nut slightly.
(c) Turn the adjusting nut so that
free-play is about 5mm.
(d) Then, tighten the lock nut.
(e) Slide the cable cap back.
T300
FREE PLAY=5mm
FREE PLAY=5mm
C300
CABLE CAP
LOCK NUT
ADJUSTING NUT