Nylon Line Head Installation - Shindaiwa C302 Operator's Manual

ASSEMBLY
4. Slide shield with cut off knife
(M) onto shield base. Secure
shield with bolt and nut (J,K)
Nylon Line Head
Installation
Parts Required:
Wear Gloves or personal injury may result:
Cutoff knife is sharp.
◆
Gearcase and surrounding area may be hot.
◆
1. Make sure shield with cutoff knife and upper plate are properly
installed.
2. Align hole in upper plate with notch in edge of gear housing and insert
head locking tool (H)
3. Thread line head (I) onto PTO
shaft by turning it
counterclockwise until head is
tight against upper plate.
4. Remove locking tool (H).
Semi-automatic nylon line heads
must be used only with debris
shield with cut-off knife. Using
nylon line heads with debris shield without cutoff knife can result in
trimmer damage, caused by operation with excessive line length.
Note: Your nylon line head may appear different than nylon line head
shown.
22
Nylon Line Head.
J
M
I
C302
J
K
H
H
X7502350400
© 5/2018 ECHO Inc.