C302
ASSEMBLY
U-Handle Installation
Parts required: U-handle, upper U-handle clamp, four U-handle bolts.
1.
Position U-handle as shown.
Install upper U-handle clamp
(A) and secure with four
U-handle bolts (B).
2.
Route throttle linkage and
ignition lead assembly along
shaft and clip as shown.
Throttle Linkage and Ignition Leads
1.
Close choke and remove air
filter cover.
2.
Place throttle wire assembly (A)
into adjustment fixture (B) and
install wire end into large
carburetor throttle swivel hole
(C).
3.
Turn throttle wire retaining clip
(X) clockwise to lock into place.
4.
Check throttle for freedom of
movement and that wide open
throttle / low idle extremes are adjusted properly.
X7502350403
© 05/22 ECHO Incorporated
A
B
A
D
E
C
ASSEMBLY
B
X
19