Starting Warm Engine - Shindaiwa C302 Operator's Manual

OPERATION
After engine fires (or 5 pulls), move choke lever back to RUN
position. Firmly grasp throttle handle and throttle trigger lockout with left
hand and fully depress throttle trigger to wide open position. Pull recoil
starter handle/rope until engine starts and runs. Release throttle trigger,
and allow unit to warm up at idle for several minutes.
Note: If engine does not start with choke in "RUN" position after 5
pulls, repeat instructions 2 - 5.
6. Throttle Trigger
After engine warm-up, grip throttle handle and support handle. Depress
the throttle trigger lockout, and gradually depress throttle trigger to
increase engine RPM to operating speed.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO NOT close the
choke, and do not hold throttle trigger fully depressed.
The attachment should not move at idle, otherwise serious
personal injury may result.
Note: If attachment moves, readjust carburetor according to
"Carburetor Adjustment" instructions in this manual or see
your dealer.
1. Stop Switch
Move stop switch button (A)
backward away from the STOP
position.
32
A
© 5/2018 ECHO Inc.
C302
( )
X7502350400