— Playback – Basics —
Playing back a tape
You can monitor the playback picture on the LCD screen. If you close the LCD panel,
you can monitor the playback picture in the viewfinder. You can also control playback
using the Remote Commander supplied with your camcorder.
(1) Install the power source and insert the recorded tape.
(2) Set the POWER switch to VCR while pressing the small green button. The
power lamp lights up.
(3) Press OPEN to open the LCD panel.
(4) Press
(5) Press
(6) Adjust the volume following the steps below.
1 Press FN to make PAGE1 appear (p. 16).
2 Press VOL. The screen to adjust volume appears.
3 Press –/+ to adjust the volume.
– : to make the volume down
+: to make the volume up
(7) Press
4
3
To return to FN
Press EXIT.
To stop playback
Press x.
to rewind the tape.
to start playback.
OK to return to PAGE1.
5
1
2
POWER
LOCK
6
FN
–
VOL
the bar indicator
OK
+
27