Inserting A Scene From A Vcr - Sony Handycam DCR-PC5 Operating Instructions Manual

Inserting a scene from a VCR

Replacing recording on a tape – Insert Editing
You can insert a new scene from a VCR onto your originally recorded tape by
specifying the insert start and end points. Use the Remote Commander for this
operation. Connections are the same as on page 58 or 59.
Insert a cassette containing the desired scene to insert into the VCR.
(1) Set the POWER switch to VCR.
(2) On the VCR, locate just before the insert start point [a], then press X to set the
(3) On your camcorder, locate the insert end point [c] by pressing m or M.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
(5) On your camcorder, locate the insert start point [b] by pressing m. Press FN
(6) Press REC PAUSE.
(7) First press X on the VCR, and after a few seconds press REC START on your
76
VCR to the playback pause mode.
Then press X to set it to the playback pause mode.
MEMORY indicator flashes and the end point of the insert is stored in
memory.
and select REC CTRL in PAGE3.
camcorder to start inserting the new scene.
Inserting automatically stops near the zero point on the tape counter. Your
camcorder automatically returns to the recording stop mode.
[a]
[b] [c]