Power On; Switching Power On; Verifying Leds; Closing And Securing The Repeater - Axell Wireless MBF-40 Series Product Description And User's Manual

AXELL MBF -40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER'S MANUAL

3.10 Power ON

3.10.1 Switching Power ON

CAUTION!! Make sure the antenna cables or 50 ohm terminations are connected to
the repeater's antenna connectors before the repeater is turned on.
To switch power on
1. Switch on the Main Power Switch.
2. Switch on the Secondary Power Supply (model dependent).
3. Switch on the Battery power.
Note: Both power supplies must be switched ON to power up the unit.
Secondary
Power Supply
Battery
Switch
NOTE: The power switches have two positions: "on" and "stand by". In the stand by position the
repeater is still connected to the power supply but not operational.

3.10.2 Verifying LEDs

Verify the LEDs from the following modules are indicating correct operation (see section
7.4):
Control module
•
F/O converter(s)
•
Power supply module(s)
•

3.11 Closing and Securing the Repeater

Close lid, tighten the screws and lock repeater. Continue with the following section to
setup the repeater.
NOTE: The two screws must be fully tightened. Failure to do so may affect the IP65 compliancy and
therefore any warranty.
46
Figure 3-37: MBF-40 Power Module
Doc. No. 00071UM Rev. 3.2
Main Power
Supply
Main Power
Switch
© Axell Wireless Ltd