External Interfaces - Axell Wireless MBF-40 Series Product Description And User's Manual

1.7.2 External Interfaces

The repeater's interfaces are located on the underside. Two basic models are available:
single and dual service antennas.
NOTE: The external connections at the bottom of the repeater can be protected with a cover which is
screwed in place.
Power
Power
The following table provides a description of the front screenl ports and connections.
Port Description
Server Service antenna connection - DIN 7/16" connector, female
Optic SC/APC Fiber optic inlet through which the optic Fiber is routed for
internal connections (section 3.7).
For MIMO models – route the two Fibers via the Fiber port.
NOTE: Optic Fiber Conduit hose fitter may be pre-assembled.
Power Plinth connection for routing power for internal connection (section
3.9)
Plinth connector for routing external alarms and relay wiring cable
Alarms
for internal connections (section 3.8).
GND
Grounding lug (section 3.5)
© Axell Wireless Ltd
PRODUCT DESCRIPTION AND USER'S MANUAL
Ground Fiber input
Figure 1-7: Single Service Antenna
Fiber Input
Figure 1-8: Dual/MIMO Service Antenna
Doc. No. 00071UM Rev. 3.2
AXELL MBF-40 AMERICAS REPEATER
Server External
antenna alarms
Service
Alarms
Antennas
7