Various Playback Modes - Sony DCR-IP5E/IP7E Operating Instructions Manual

Playing back a tape
Various settings
Various settings is your camcorder's information
when you recorded. In recording mode, the
various settings are not displayed.
When you use the data code function, bars
(-- -- --) appear if:
– A blank portion of the tape is being played
back.
– The tape is unreadable due to tape damage or
noise.
– The tape was recorded by a camcorder without
the date and time set.
– The camcorder is in various playback modes.
Data code
When you connect your camcorder to a TV, the
data code also appears on the TV screen.
Remaining battery time indicator during
playback
The indicator shows the approximate continuous
playback time. The indicator may not be correct,
depending on the conditions in which you are
playing back. When you close the LCD panel and
open it again, it takes about 1 minute to display
the correct remaining battery time.

Various playback modes

To operate the video control buttons, set the
POWER switch to VCR.
To view a still image (playback
pause)
•Select , then press the centre z on the
control button during playback. To resume
normal playback, select
centre z on the control button again.
•Press PAUSE on the Remote Commander
during playback. To resume normal playback,
press PAUSE again.
56
, then press the
z
z