Sony DCR-IP5E/IP7E Operating Instructions Manual page 27

Step 1 Preparing the power
supply
(1) Open the jack cover and connect the AC
power adaptor supplied with your camcorder
to the DC IN jack with the plug's v mark
facing the lens side.
(2) Connect the mains lead to the AC power
adaptor.
(3) Connect the mains lead to the mains.
(4) Set the POWER switch to OFF (CHG).
The CHG lamp lights up when the charge
begins. After the charge is completed, the
CHG lamp goes out (full charge).
2
After charging the battery pack
Disconnect the AC power adaptor from the DC
IN jack on your camcorder.
(1)
(2)
(3)
(4)
4
POWER
CAMERA
MEMORY/ (CHG)
NETWORK
OFF
VCR
ON
MODE
1
CHG lamp/
v
27