Removing The Display Assembly; Prerequisites; Procedure - Dell Alienware Area-51m Service Manual

Removing the display assembly

WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in After working inside your
www.dell.com/regulatory_compliance.

Prerequisites

1 Remove the base cover.
2 Remove the wireless
3 Remove the rear-I/O

Procedure

1 Remove the screw (M2x3) that secures the display-cable bracket to the system board.
2 Lift the display-cable bracket off the system board.
3 Using the pull tab, disconnect the display cable from the system board.
4 Disconnect the camera cable from the system board.
5 Peel off the display cable and the camera cable from the computer base.
6 Disconnect the tobii cable from the system board.
7 Remove the antenna cables from the routing guides on the computer base.
8 Peel off the tobii cable from the computer base.
52
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
card.
cover.
computer. After working inside your computer, follow the instructions