Removing the solid-state drives
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in
After working inside your
www.dell.com/regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
CAUTION: To avoid data loss, do not remove the solid-state drive while the computer is in sleep or on state.
Prerequisites
Remove the
base
cover.
Procedure to remove M.2 2230 card
NOTE: This procedure applies only to computers shipped with a M.2 2230 card installed.
NOTE: Depending on the configuration ordered the computer may have up to two M.2 cards installed. Supported
card configurations per M.2 card slot:
•
M.2 2230 solid-state drive
•
M.2 2280 solid-state drive/Intel Optane storage
1
Remove the screw (M2x3) that secures the M.2 thermal shield to the palm-rest assembly and system board.
2
Lift the M.2 thermal shield from the palm-rest assembly and system board.
3
Remove the screw (M2x3) that secures the M.2 2230 card to the palm-rest assembly.
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
computer. After working inside your computer, follow the instructions
29