Replacing the audio daughter-board
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in
After working inside your
www.dell.com/regulatory_compliance.
Procedure
1
Slide the audio daughter-board at an angle into the slot on the palm-rest assembly.
2
Replace the three screws (M2.5x2.5) that secure the audio daughter-board to the palm-rest assembly.
3
Connect the audio daughter-board cable to the connector on the audio daughter-board and close the latch to secure the
cable.
4
Adhere the tape that secures the audio daughter-board cable.
5
Connect the speaker cable to the audio daughter-board.
Post-requisites
1
Replace the
base
cover.
2
Follow the procedure from step 4 to step 7 in
42
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
computer. After working inside your computer, follow the instructions
Replacing the hard
drive.