Table of Contents
Advertisement
(3) For wiring of the inverter with one front cover, route wires between the control circuit terminal block and
front cover. If cables can not be routed between the control circuit terminal block and front cover due
to the increased number of cables, remove a hook of the front cover and use a space become available.
For wiring of the inverter which has front cover 1 and 2, use the space on the left side of the control
circuit terminal block.
Front cover
Inverter with one front cover
REMARKS
• When the hook of the inverter front cover is cut off for wiring, the protective structure (JEM1030) changes to open
type (IP00).
When performing wiring using the space between the inverter front cover and control circuit
terminal block, take caution not to subject the cable to stress.
After wiring, wire offcuts must not be left in the inverter. These may cause a fault, failure or
malfunction.
INSTALLATION AND WIRING (FR-A700/F700 SERIES)
Cut off
with a
nipper,
etc.
Cut off a hook on the inverter
front cover side surface.
(Cut off so that no portion is left.)
CAUTION
Front cover 1
Front cover 2
Inverter which has front cover 1 and 2
Control circuit
terminal block
2
10
Advertisement
Table of Contents
