Appendix 1 Instructions for compliance with the EU Directives
The EU Directives are issued to standardize different national regulations of the EU Member States and to
facilitate free movement of the equipment, whose safety is ensured, in the EU territory.
Since 1996, compliance with the EMC Directive that is one of the EU Directives has been legally required.
Since 1997, compliance with the Low Voltage Directive, another EU Directive, has been also legally required.
When a manufacturer confirms its equipment to be compliant with the EMC Directive and the Low Voltage Directive, the
manufacturer must declare the conformity and affix the CE marking.
The authorized representative in the EU
The authorized representative in the EU is shown below.
Name: Mitsubishi Electric Europe B.V.
Address: Mitsubishi-Electric-Platz 1, 40882 Ratingen, Germany
• To use this product in the EU, the operating capacity of the relay outputs should be 30 VDC, 0.3 A. (Relay output has basic
isolation from the inverter internal circuit.)
We declare that this product conforms with the EMC Directive when installed in a compatible inverter, and affix the CE marking
on the packaging plate.
• EMC Directive: 2004/108/EC
• Standard(s): EN 61800-3:2004+A1:2012 (Second environment / PDS Category "C3")
• To install and wire the inverter, refer to the "Instructions for compliance with the EU Directives" in the Instruction Manual
enclosed with the inverter.
• Confirm that the final integrated system with the inverter conforms with the EMC Directive.