INSTALLATION AND WIRING (FR-E700 SERIES (E kit))
Make sure that the input power of the inverter is off.
With input power on, do not install or remove the plug-in option. Otherwise, the inverter and
plug-in option may be damaged.
For prevention of damage due to static electricity, touch nearby metal before touching this
product to eliminate static electricity from your body.
The FR-E700 series has one connection connector for the plug-in option.
Always perform wiring to the main circuit terminals and control circuit
terminals before installing the option. Wiring cannot be performed after
installing the option.
For wiring to terminal RUN, FU, SE of control circuit terminal, run cables
to prevent them from being caught between the option board and control
circuit terminal block as shown in the right figure. In case cables are
caught, the inverter may be damaged.
When the inverter cannot recognize that the option is mounted due to
improper installation, etc., "
When installing/removing the plug-in option, hold the sides of the option.
Do not press on the parts on the option circuit board. Stress applied to
the parts by pressing, etc. may cause a failure.
Take care not to drop a mounting screws during mounting and removal.
Pull out the option straight to remove. Otherwise, the connector and to
the option circuit board may be damaged.
" (option alarm) is displayed.