Specifications; Maintaining The Scale; Before Requesting Service - A&D UC-321 Instruction Manual

Specifications

Digital display
Maximum capacity
Minimum display
Power source
Battery life
Accessories
Specifications are subject to change without prior notice and any obligation
on the part of the manufacturer.

Maintaining the Scale

Clean the scale with a dry, soft cloth or a cloth moistened with water and a
mild detergent. Never use alcohol, benzene, thinner or other harsh chemi-
cals to clean the scale.
Remove the batteries, if the scale is not going to be used for a long time.

Before Requesting Service

If this happens
Nothing is displayed by pressing the
measurement switch.
The indication is fixed to
or is displayed.
The difference between an estimated
weight and a measured weight is bigger.
is displayed.
If you can not locate and fix the problem, contact your supplier, or the A&D
service group. The A&D service group will support authorized suppliers
about technical information, spare parts and units.
A&D Co.,LTD.
1-243 Asahi, Kitamoto-shi, Saitama, 364-8585 JAPAN
Telephone: [81] (485) 93-1111 Fax: [81] (485) 93-1119
A&D INSTRUMENTS LTD.
<Authorized Representative Established in the European Community>
Unit 24/26 Blacklands Way, Abingdon Business Park, Abingdon, Oxon OX14 1DY United Kingdom
Telephone: [44] (1235) 550420 Fax: [44] (1235) 550485
Liquid crystal display, 25 mm character height
150 kg
0.05 kg
Four type AA batteries (R6P, 1.5 volt x 4)
Approximately 2000 measurements
Instruction manual
Check the battery installation.
Replace with four new batteries.
.
Remove and reinstall the batteries.
Move your scale to a flat, solid surface.
Does the under case touch to the floor?
Replace batteries and try again.
Please do this