Pa-220R Front Panel - PaloAlto Networks PA-220R Hardware Reference Manual

PA-220R Front Panel

The following image shows the front panel of the PA-220R firewall and the table describes each front-panel
component.
Item Component
1 Screw-on ground point
2 DC power and ground inputs
3 Ethernet ports 1 through 6
4 SFP ports 7 and 8
5 MGT port
6 CONSOLE port (RJ-45)
PA-220R NEXT-GEN FIREWALL HARDWARE REFERENCE | PA-220R Firewall Overview
Description
Use this ground point to connect the firewall to earth
ground (ground cable not included).
Use the DC input terminal block to connect DC power
to the firewall. The terminal block is included in the
accessories kit and is labeled A+, A-, B+, and B-.
The two inputs to the right of the four DC power inputs
are ground inputs (use only one) that you can use in
place of the screw-on ground point on the firewall (see
Connect Power to a PA-220R
Six RJ-45 10Mbps/100Mbps/1000Mbps ports for
network traffic. You can set the link speed and duplex
or choose auto-negotiate for each port. These ports also
have built-in surge protection.
Two SFP (1Gbps) ports for network traffic.
These ports also support 100Base-FX.
Use this Ethernet 10Mbps/100Mbps/1000Mbps port
to access the management web interface and perform
administrative tasks. The firewall also uses this port for
management services, such as retrieving licenses and
updating the threat and application signatures.
Use this port to connect a management computer to the
firewall using a 9-pin serial-to-RJ-45 cable and terminal
emulation software.
The console connection provides access to firewall boot
messages, the Maintenance Recovery Tool (MRT), and
the command line interface (CLI).
If your management computer does not
have a serial port, use a USB-to-serial
converter.
Firewall).
2018 Palo Alto Networks, Inc.
©
15