Connections
Connecting a Number of Camcorders
When using two or more synchronized camcorders,
connect an external sync signal to the GEN LOCK IN
connector, supplying a VBS or BS signal. The
camcorder will then operate synchronized to this
signal.
Example 1: Camcorder 2 synchronized
to the signal from camcorder 1
DSR-300/300P
Camcorder 1
VTR
VIDEO OUT
CCZ-A Camera Cable
Example 2: Camcorders 1 and 2 synchronized to the signal from a special effects unit or similar
Video input connector
Sync signal output
connector
Special effects
unit or similar
Video input connector
Sync signal output
connector
Connecting an External VCR
You can use a following external VCR connected to
the VTR connector (26-pin) for recording.
VCR
Connecting cable
BVW-50/50P/35/35P
CCZ-A Camera cable (max. length
(portable)
10 m (33 ft.))
VO-8800/6800
CCZQ-A Camera cable (max. length
(U-matic)
10 m (33 ft.))
You can adjust the synchronization using the basic
menu. (See page 79.)
BNC cable
Portable VTR
To camera
To video input
connector
connector
BNC cable
BNC cable
VIDEO OUT
GEN LOCK IN
BNC cable
BNC cable
VIDEO OUT
BNC cable
GEN LOCK IN
Notes
• This is no power supply connection between the
camcorder and VCR. Provide separate power
supplies.
• The VTR connector always outputs the signals from
the camera (impossible to output the playback video
of the internal VCR), and disallows the CCU
connection.
DSR-300/300P
Camcorder 2
GEN LOCK IN
VIDEO OUT
DSR-300/300P
Camcorder 1
DSR-300/300P
Camcorder 2
Chapter 2 Fitting and Connections
43