Karma Morgan Series User Manual page 70

Figure 5.3.19-8 Figure 5.3.19-9
Cut the tie which is used to fasten the seat frame and the fixing base before installing the fixing bracket in
the fixing base. (Figure 5.3.19-9)
Use part E to fasten fixing bracket on the seat frame. There are four sets of screws and nuts. Two sets are
used for either side. (Figure 5.3.19-10)
Figure 5.3.19-10
Insert hex head shoulder bolt into the upper hole on the base of the tilt actuator. Use the hex Nylon dome
nut to fasten the bolt in order to fix the tilt actuator on the seat frame. (Figure 5.3.19-11)
Connect the connector of the tilt actuator to the connector fixed on the right side of the seat frame. (Figure
5.3.19-12)
Figure 5.3.19-11 Figure 5.3.19-12
70