Karma Morgan Series User Manual page 69

Figure 5.3.19-4
Insert the hex head shoulder bolt through the top hole of the recline actuator. Use hex Nylon dome nut to
fix the bolt. (Figure 5.3.19-6)
Use part C to tighten the cable of recline actuator on the Aluminum tube. (Figure 5.3.19-7)
CAUTION
Make sure the cable is properly routed to prevent it from being damaged or pulled when the
actuator is operated between the uppermost position and the lowermost position.
Take the tilt actuator and the fixing bracket out of the package. Insert the Clevis pin through the lower hole
on the rod of the tilt actuator. Insert E ring into the slot of the pin in order to fix the tilt actuator on the
fixing bracket. (Figure 5.3.19-8)
CAUTION
Part Clevis Pin shall be inserted into to the lower hole.
CAUTION
Do not insert part Clevis Pin into to the upper hole.
Figure 5.3.19-5
Figure 5.3.19-7
Figure 5.3.19-6
69