Chapter 6: Turning power on and off to the
storage systems
The following describes the prerequisites and procedures for turning the power on and
off to the VSP G1000, VSP G1500, and VSP F1500 storage systems during normal
operating conditions or a power failure.
Power control panel
The power control panel is located in the top left corner of the controller. It is covered by
a 2U-high bezel that can be removed separately from the 8U bezel that covers the rest of
the controller.
The following illustration shows the switches and indicators on the control panel. The
following table lists the components and LED descriptions. All LEDs are shown ON to
demonstrate the LED color.
Figure 38 Storage system power control panel
Table 26 Storage system power controls and status indicators
Item
1
REMOTE MAINTENANCE switch
Set to ENABLE to allow remote maintenance.
■
Set to DISABLE to prevent remote maintenance.
■
2
ENABLE switch: Used to enable the PS ON/PS OFF switch. See
page 122)
.
Chapter 6: Turning power on and off to the storage systems
Hitachi Virtual Storage Platform G1000, G1500, and VSP F1500 Hardware Guide
Description
Power on procedures (on
119