Siemens SINAMICS S120 Equipment Manual page 91

Cable routing for DRIVE-CLiQ connections and signal cables, frame sizes HX+HI and JX+JI
1. Feed the cable for the DRIVE-CLiQ/signal cables into the cabinet from the bottom left.
2. Use cable ties to secure the cable at suitable points.
3. Feed the cable up through the cabinet and, when it reaches the Control Unit CU320,
4. Use cable ties to secure the cable at suitable points.
5. Connect DRIVE-CLiQ/signal cable to the CU320.
S120 Cabinet Modules Equipment Manual
Manual, (GH5), 10/2008, A5E00427098A
HX+HI
guide it up and to the right toward the CU320. When doing so, route the cable in a
similar manner to the standard cables that have already been installed in the cabinet.
Frame size:
JX+JI
Electrical installation
4.5 Connections
91