Assembly; Unpacking; Tools Needed - PowerTec MT4005 Owner's Manual

2

UNPACKING

Refer to Figure 1
Check for shipping damage. Check immediately that all
parts and accessories are included.
ITEM DESCRIPTION
A Main Frame
B Leg Extension
2
C Foot
D Wheels
E Roller Bars
F Handle
G Locking Knobs
H Locking Knobs (star)
I Hex Bolt (M12x75 mm) (wheel)
J Hex locking nut M12 (wheel)
K Phillip Pan Head Screw M6x35 (handle)
L Curved Washer (leg extension/foot)
M Phillip Pan Head Screw M6x12
(leg extension/foot)
N Feet End Caps
O Miter Saw Mounting Hardware
(mounting bolt, washer, lock washers and nut)
Figure 1
A
C
D
J
O
WARNING
Do not use the miter saw stand until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with this miter saw stand.
WARNING
Do not use the miter saw stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 440 lbs (200 kg). Power tools
on the miter saw stand should not exceed a combined
overall height of 60" (152.4 cm) from the floor.
F
E H
I
L M

ASSEMBLY

TOOLS NEEDED

The following tools (not included) are needed to assemble
the miter saw stand:
1 - Phillips screw driver (handle, leg extension and foot
QTY
assembly)
1
2 - Adjustable wrenches or two 19 mm wrenches
1
(wheel assembly)
1
ASSEMBLY
2
2
Refer to Figure 2–9
1
• Press the feet end caps onto the leg extension.
4
2
• Place the main frame onto the table top as shown. Slide
2
leg extension into main frame and secure with curved
2
washers and pan head screws.
2
• Lift the main frame and slide foot into main frame and
4
secure with curved washers and pan head screws.
4
Figure 2
2
4
Foot
• Slide the hex bolt through the wheel and main frame leg.
Secure with hex locking nut on the inside of mainframe.
DO NOT over tighten, if too tight the wheels will not turn.
• Repeat with other wheel.
K
NOTE: Raised hub goes to the inside.
Figure 3
G
N
Raised
Hub
B
Hex
Locking
Nut
• Thread the locking knob (star shaped) onto the adjusting
bracket screw. Repeat on other side. DO NOT tighten
the locking knobs at this time.
Figure 4
Adjusting Bracket
Feet End
Main Frame
Caps
Leg Extension
Table Top
Hex Bolt
Wheel
Main Frame Leg
Adjusting Bracket Screw
Locking Knob (star)