Assembly; Mounting The Miter Saw - PowerTec MT4005 Owner's Manual

• Turn the stand over to rest on the leg extension
and wheels.
• Assemble the handle to the main frame with two pan
head screws. Tighten securely.
Figure 5
• Place one foot on the leg extension to hold the stand
in place. Depress the release lever, lift and slightly
pull the table top towards you and raise the table top
until it latches in place. Tighten the locking knobs on
each side.
Figure 6
Table Top
NOTE: The locking knob must be loose to raise the stand.
NOTE: Take care when raising the miter saw stand to
reduce the hazard of pinching hands and fingers.
• Place the roller arm into the roller bar support, slide up
and down to desired location and secure in place with
roller bar locking knobs.
• Thread the extension bar locking knobs into the
extension bar.
• Repeat on other side.

ASSEMBLY

Handle
Release Lever
Extension
Handle
Figure 7

MOUNTING THE MITER SAW

Refer to Figure 8
WARNING
Risk of accidental starting and serious personal injury.
Unplug the miter saw before attaching it to the miter
saw stand.
WARNING
Risk of serious personal injury. Always make sure the
miter saw is fully supported and securely attached to
a level work surface. Make sure the miter saw stand is
located on a flat surface.
WARNING
Do not mount a table saw on this miter saw stand.
Aggressive feeding of sheet materials into a table saw
could cause the stand to tip over.
• Place the miter saw to be used on the table top.
• Move the miter saw around until the hole pattern
Leg
matches the slot combination on the table top, secure
with the mounting hardware supplied.
• Insert the bolt through the bottom of the table and
secure with flat washer, lock washer and nut.
Figure 9
Extension Bar
Locking Knobs
Roller Bar
Nut
Lock Washer
Flat Washer
Bolt
3
3
Roller Bar
Locking
Knobs