Assembly; Unpacking; Tools Needed; Assemble Handle - PowerTec MT4008 Owner's Manual

2

UNPACKING

Refer to Figure 1
Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM DESCRIPTION
A Miter Saw Stand
B Quick Release Mounting Brackets
2
C Roller Bars
D Locking Knobs, plain threads (roller bars)
E Locking Knobs, threads with plastic cap
(extension bar)
F Wheels
G Axle
H Locking Nut M8 (wheels)
I Washer Ø8 [wheels (4), handle (2)]
J Washer Ø12 (wheels)
K Handle
L Bolt (handle)
M Lock Washer (handle)
N Miter Saw Mounting Hardware
(mounting bolt, washer, lock washers
and nut)
Figure 1
A
B
F
C
WARNING
Do not use the miter saw stand until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with this miter saw stand.
WARNING
Do not use the miter saw stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 330 lbs (150 kg). Power tools
on the miter saw stand should not exceed a combined
overall height of 60" (152.4 cm) from the floor.
M
I
K
G
N
D
E

ASSEMBLY

TOOLS NEEDED

The following tools (not included) are needed to assemble
the miter saw stand:
Phillips screwdriver
QTY
13 mm wrench or socket
1
2

ASSEMBLE HANDLE

2
Refer to Figure 2
2
2
• Secure handle to frame with hardware supplied.
Figure 2
2
2
4
6
2
1
2
2
4
Handle

UNFOLD THE WORK LEGS

Refer to Figure 3
• Place the miter saw stand on a flat surface with the
folded legs facing up.
• Depress the release lever and rotate the leg until it
clicks and locks into the open position. Repeat for
each leg.
L
Figure 3
I
H
J
• Place the miter saw stand in the upright position on a
flat surface.
Bolt
Lock
Washer
Washer (Ø8)