Page 1
Model No. MT4005 Owner’s Manual MITER SAW STAND QUESTION... 1•847•780•6120 Visit us on the web at www.southerntechllc.com You will need this manual for safety instructions, operating procedures, and warranty. Put it and the original sales invoice in a safe, dry place for future reference.
TABLE OF CONTENTS PRODUCT SPECIFICATIONS SECTION PAGE SAFETY RULES Net Weight: ........49.5 lbs (22.5 kg) Weight Capacity: ......440 lbs (200 kg) Table Size: ........32-9/32" x 18-1/32" ASSEMBLY ............820 mm x 458 mm Table Height: ........26-31/32" x 32-9/32" Unpacking ............685 mm x 820 mm Tools Needed Roller Extension Range: ....
SAFETY RULES • Store properly. Do not store the miter saw stand WARNING outdoors or in a damp location. • Do not stand or climb on miter saw stand. It could tip For your own safety, read all of the rules and precautions over, causing serious injury.
ASSEMBLY UNPACKING TOOLS NEEDED Refer to Figure 1 The following tools (not included) are needed to assemble Check for shipping damage. Check immediately that all the miter saw stand: parts and accessories are included. 1 - Phillips screw driver (handle, leg extension and foot ITEM DESCRIPTION assembly) Main Frame...
ASSEMBLY Figure 7 • Turn the stand over to rest on the leg extension Extension Bar and wheels. Locking Knobs • Assemble the handle to the main frame with two pan head screws. Tighten securely. Roller Bar Figure 5 Roller Bar Locking Handle Knobs...
OPERATION TO RAISE AND LOWER THE STAND WARNING Refer to Figure 11 Do not use the miter saw stand for scaffolding or as a The stand has three positions. ladder. Make sure to securely tighten all fasteners before Position 1: Work Height (82 cm) using.
TRANSPORTATION NOTE: Storing the stand in the vertical position with the saw attached is a tipping hazard. Refer to Figure 12, 13 Figure 13 WARNING Risk of unsafe operation. Ensure proper footing and use caution when rolling the miter saw stand to prevent tipping or loss of balance.
30- DAY SATISFACTION GUARANTEE POLICY During the first 30 days after the date of purchase, if you are dissatisfied with the performance of this POWERTEC tool for any reason, you may return the tool to the retailer from which it was purchased for a full refund or exchange. You must present proof of purchase and return all original equipment packaged with the original product.