PowerTec MT4002 Instruction Sheet

INSTRUCTION SHEET
MITER SAW STAND
QUESTION...
1•847•780•6120
IMPORTANT
Due to a manufacturing change the Owner's Manual
provided with your tool DOES NOT cover all of the
assembly. USE this sheet along with the provided Owner's
Manual to assemble this tool.
UNPACKING
Refer to Figure 1 on this sheet
Check for shipping damage. Check immediately that all
parts and accessories are included.
ITEM DESCRIPTION
A Main Frame
B Top Frame
C Cross Bar
D Cross Bar Hardware (M6 bolt, washer, nut)
E Quick Release Mounting Brackets
F Roller Bars
G Handle
H Screw (handle)
I Wheels
J Bolts (wheel)
K Washers (wheel)
L Axle sleeves (wheel)
M Lock nuts (wheel)
N Feet
O Miter Saw Mounting Hardware
(mounting bolt, washer, lock washers and nut)
Figure 1
A
B
E
G
F
D
H
O
QTY
E
I
C
N
J K L M

TOOLS NEEDED

The following tools (not included) are needed to assemble
the miter saw stand:
1 - 4 mm hex wrench (Frame assembly)
1 - 10 mm open end wrench (Frame assembly)
1 - 13 mm socket (Frame assembly)
1 - Phillips screw driver (handle assembly)
2 - Adjustable wrenches or two 19 mm wrenches
(wheel assembly)
ASSEMBLE FRAME
Refer to Figure 2–6
• Place the main frame as shown in Figure 2. Rotate the
folding arm up.
Figure 2
1
Main Frame
1
1
2
2
• Use the M6 bolts, washer and nuts to assemble the
2
cross bar to the main frame (Figure 3). Rotate the
1
folding arm back down after the crossbar is assembled.
2
Figure 3
2
2
4
2
2
2
Folding Arm
M6 Bolt
4
• Place the top frame upside down as shown in Figure 4.
Temporarily remove the bar lock and top frame
mounting nuts.
folding arm
Cross Bar
M6 Bolt
Washer
Washer
Nut
folding arm down
MT4002
Nut
16-1108